INCH-POUND
MIL-DTL-20277K
1 May 2014
SUPERSEDING
MIL-DTL-20277J
20 September 2007
DETAIL SPECIFICATION
KNIFE, COMBAT; AND SHEATH,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and
Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the requirements for a knife combat; and sheath.
1.2 Part or Identifying Number (PIN). The definitive specification PIN will be formatted to identify
each item covered by this specification. The PIN format will consist of the letter M, specification number,
a slash sheet number a dash and a letter for knife and sheath and a number for service marking as
follows:
M
20277
/1
-S
1
Service marking, see slash sheet.
Dash letter in see slash sheet
Slash sheet number
Specification number
M prefix
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification or
recommended for additional information or as examples. While every effort has been made to ensure the
completeness of this list, document users are cautioned that they must meet all specified requirements
documents cited in sections 3 and 4of this specification, whether or not they are listed.
Comments, suggestions, or questions on this document should be addressed to: DLA Land and Maritime, Attn:
VAI, P.O. Box 3990, Columbus, OH 43218-3990, or emailed to FluidFlow@dla.mil. Since contact information can
change, you may want to verify the currency of this address information using the ASSIST Online database at
AMSC N/A
FSC 1095
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business