MIL-D-63123B(AR)
14 January 1985
SUPERSEDING
MIL-D-63123A(AR)
17 December 1983
MILITARY SPECIFICATION
DISPENSER ASSEMBLY
This Specification is approved for use by the U.S. Army Armament,
Munitions and Chemical Command, and is available for use by all
Depertments and Agencies of the Department of Defense.
SCOPE
1.
1.1 Scope. This Specification covers the performance and
acceptance inspection requirements for the Dispenser Assembly
associated with the M130 Aircraft General Purpose Dispenser.
2.
APPLICABLE DOCUMENTS
2.1 Government documents.
2.1.1 Specifications and standards. Unless otherwise specificd
(see 6.2), the following specifications and standards of the issue
listed in that issue of the Department of Defense Index of
Specifications and Standards (DoDISS) specified in the solicitation,
form a part of this specification to the extent specified herein.
SPECIFICATIONS
MILITARY
- Soldering, Manual Type, High Reliability,
MIL-S-45743
Electrical and Electronic Equipment
- Solder Bath Soldering of Printed Wiring
MIL-S-46844
Assemblies
- Ammunition, Standard Qualtiy Assurance
MIL-A-48078
provisions, General specification For
STANDARDS
MILITARY
- Sampling Procedures and Tables for
MIL-STD-105
Inspection by Attribute
- Environmental Test Methods
MIL-STD-810C
FSC
1095
Beneficial comments (recommendations, additions deletions) and pertinent
data which may be of use in improving this document should be addressed
to Commander. US Army Armament Research and Development Center, Attn
DRSMC-QA, Dover. New Jersey 07801 by using the self-addressed Standardization
Document Improvement Proposal (DD Form 1426) appearing at the end of this
document or by letter
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business